Correct T3S3 flashing

diff --git a/Makefile b/Makefile
index 6d40a9a3053e541ed26b793560f8b91aadad8ef0..e463d3f7f45f95f168c1da069a28d0de5be90ec1 100644 (file)
--- a/Makefile
+++ b/Makefile
@@ -224,11 +224,17 @@ upload-rnode_ng_21:
        python3 ./Release/esptool/esptool.py --port $(or $(port), /dev/ttyACM0) $(COMMON_ESP_UPLOAD_FlAGS) ./Release/console_image.bin
 
 upload-t3s3:
+       @echo
+       @echo Put board into flashing mode by holding BOOT button while momentarily pressing the RESET button. Hit enter when done.
+       @read
        arduino-cli upload -p $(or $(port), /dev/ttyACM0) --fqbn esp32:esp32:esp32s3
+       @sleep 2
+       python ./Release/esptool/esptool.py --chip esp32s3 --port $(or $(port), /dev/ttyACM0) --baud 921600 --before default_reset --after hard_reset write_flash -z --flash_mode dio --flash_freq 80m --flash_size 4MB 0x210000 ./Release/console_image.bin
+       @echo
+       @echo Press the RESET button on the board now, and hit enter
+       @read
        @sleep 1
        rnodeconf $(or $(port), /dev/ttyACM0) --firmware-hash $$(./partition_hashes ./build/esp32.esp32.esp32s3/RNode_Firmware_CE.ino.bin)
-       @sleep 3
-       python ./Release/esptool/esptool.py --chip esp32s3 --port $(or $(port), /dev/ttyACM0) --baud 921600 --before default_reset --after hard_reset write_flash -z --flash_mode dio --flash_freq 80m --flash_size 4MB 0x210000 ./Release/console_image.bin
 
 upload-featheresp32:
        arduino-cli upload -p $(or $(port), /dev/ttyUSB0) --fqbn esp32:esp32:featheresp32